What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
09.06.2025 02:10

For this case there are devices called Metal oxide varistors (MOV).
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Barnstars:
Do women like watching men sucking men?
It also is a device that limits the change in current flow.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
There are two important concepts here.
As measles spreads across the Americas, outbreaks in Mexico and Canada have also turned deadly - CNN
so, what happens?
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
A circuit breaker is similar, but is resettable.
What type of crossdresser are you?
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Here is a simplified AC power diagram.
2024–10–16 [ OO OLAOYE OYEBODE ]
Bethenny Frankel Reveals Her Teenage Daughter Bryn's Reaction to Her SI Swimsuit Look - People.com
Because the load is inductive, the current lags the voltage.(by a bit).
nine
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Nintendo: Please don’t remove film layer from Nintendo Switch 2 screen - My Nintendo News
This is 'the assistant's answer'
He then asserts :
So, the voltage could go up to 500 volts, and the fuse will not open up.
Is modular building a fix for NY's housing crisis? State officials hope so. - Gothamist
The MOV will conduct when the voltage exceeds 50% of line voltage.
One is “what exactly is in a ‘surge protector’ ? ”
Can the fuse protect the electronic devices from lightning instead of a surge protector.
What made you feel disgusted today?
An AC voltage/ current source, and an ac inductive load.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This is where the MOV conducts again, and dissipated the energy.
A fuse is a non-resetable over current circuit protector.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
a photo is worth a thousand words.
The other is “what does a “fuse” do?”
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
[image of Common-mode choke]
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This device then solves the entire problem.
This is where this question deviates from being a 'generic' question, and becomes more specific.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
There are three different concepts here that are getting confused.
In schematic diagrams this is the symbol for a fuse:
[old diagram got deleted by accident]
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Would you join a gym or workout at home and why?
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
But it can get overloaded, and no longer works.
the problem then depends on "how fast does the fuse operate?".
It seems Mohan does not understand the difference between a comment and an Answer.
what exactly is a ‘surge’ protector?
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
(Dc diagram shown, AC is similar).
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
These are simplified answers to the original question, and does not change anything I wrote above.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
At least they know the answer if they wanted it.
The third is lightning and “how it gets conducted into a home.”
At one ohm, the resistor has a maximum of 1 watt power.
These devices are installed between the “hot” and “neutral” and protective ground.
but this device (an Inductor) … impedes the rapid changes in the current.
Edit 2024–10.
eight
This is the picture of an electronic coil of wire wound around a core of magnetic material.
What is lightning?
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
The bolt then partially travels down the line to your home.
I post the exact comment here.
First Sentence:
What does a fuse do?
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
2024–10–14 [Omar Gharbi Omar Gharbi ]
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
But… the neutral is now “floating” because of the 1 ohm resistance.
2024–10–10[John johnson John Johnson ]
Upvotes:
This one hit behind the barn.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
but I think this circuit , shows a few more pieces.
He then describes the function of a fuse.
He then describes Rainy Season and Lightning.
Now when you have a certain ac resistance, then a current flows in a loop.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
One